Carter CT12 - 1.2 Safety Operation of the Machine

SHANDONG CARTER HEAVY INDUSTRY MACHINERY CO., LTD.
17
(b) In the case of without the approval of the CARTER, for any harm caused as a result of the modification,accident
or product failure,CARTER assumes no liability whatsoever.
1.2 Safety operation of the machine
The machine is not intended for use in unhealthy enviroments, e.g. contaminated areas.
The machine is not intended for operation with a hydraulic- or demolition-hammer.
Operating the machine, the operator should wear earplugs or earmuffs.
Hydraulic excavator CT12 is suitable for I-IV soil excavation and loading operations. In the mechanized construction of
industrial and civil construction, transportation, road construction, water resources and electric engineering, farmland
transformation, it can be widely used for excavation pit channel, backfill pavement, earth mining, digging build sub
grade, stripping, mining and so on.
1.2.1. Before starting the engine
1. The check before starting the engine
 Wipe away the dust on the surface of the window glass, to ensure a good vision.
 Clean the headlights and work lights well, and check whether they are normal.
 Check the coolant level, fuel level and engine oil sump oil level.
 Check the air filters if it is blocked, and check the wires for damage.
 The seat adjusted to the easy operation, and checks the seat belt or the retaining clips damage or not.
 Check that the instrument is working properly, check the light and the angle of the lights and check the control lever
is all in the middle position.
 Adjust the rear view mirror, so that you can clearly see from the seat and the back of the machine.
 Make sure there are nobody and barrier around the machine.
2.Safety regulation for starting the engine
(a) When starting the engine, honking for warning.
(b) Only allows the driver to start or operate machine.
(c) In addition to the operator, does not allow anyone on the machine.
(d) Not allowed to start the engine by the way of which cause the starter motor short circuit, doing so is not only
dangerous, but also cause damage to the equipment.