CI-100A Indicator Operation & Service Manual
────────────────────────────────────────────────────────
CAS-USA Corporation
www.cas-usa.com 36
18. View Firmware Version
18.1 Press down SETUP until CONFIG is shown, using PRINT or ACC key to select MISC-VER item, press
TARE to display current Version.
18.2 Firmware Version display Format is: Vxx.yy, xx is hardware version, yy is software version
18.3 Press SETUP key to return to last menu item, press ON/OFF key to prepare to exit this mode
19. Display Test
19.1 Press down SETUP more than 3s to enter SETUP mode, using PRINT or ACC key to select
TEST-DISP.TST item, press TARE to enter test display mode and all segments will be lighted first.
19.2 In this mode, every pressing of ACC key will light next segment, every pressing of UNIT will light next
digit, press PRINT will automatically light all segments and all digits.
19.3 Press SETUP key to return to last menu item, press ON/OFF key to prepare to exit this mode
20. Keyboard and Buzzer Test
20.1 Press down SETUP more than 3s to enter SETUP mode, using PRINT or ACC key to select
TEST-key.tst item, press TARE to enter test keypad mode, and key. -- will be displayed.
20.2 In this mode, press a key, the value of this key will be displayed on -- position and buzzer will beep
whatever USER-BEEP-KEY item is set.
20.3 Press SETUP key to return to last menu item, press ON/OFF key to prepare to exit this mode
21. Serial Port1/2 (COM1/2) Receiving Test
21.1 Before test the receiving function of COM1 or COM2, a cable is need to connect a PC and this indicator,
and a software be similar with Super Terminal of Windows is also need to run on PC to send bytes to this
indicator. Please note: baud rate is selected by USER-COM1/2-BAUDRT, 8N1 byte format is fixed,
Hex data (0x00 – 0xff) are used.
21.2 Press down SETUP more than 3s to enter SETUP mode, using PRINT or ACC key to select
TEST-COM1.RD or TEST-COM2.RD item, press TARE to enter test COM1/2 receiving function, and
rd1.-- or rd2.--will be displayed first.
21.3 In this mode, received hex data (0x00 – 0xff) will be displayed on -- position.
21.4 Press SETUP key to return to last menu item, press ON/OFF key to prepare to exit this mode
22. Serial Port1/2(COM1/2) Transmitting Test
22.1 Before test the transmitting function of COM1 or COM2, a cable is need to connect a PC and this
instrument , and a software be similar with Super Terminal of Windows is also need to run on PC to
receive bytes from this instrument. Please note: baud rate is selected by USER-COM1/2-BAUDRT, 8N1
byte format is fixed, Hex data (0x00 – 0xff) are used..
22.2 Press down SETUP more than 3s to enter SETUP mode, using PRINT or ACC key to select
TEST-COM1.TD or TEST-COM2.TD item, press TARE to enter test COM1/2 transmitting function, and
td1.-- or td2.-- will be displayed first.
To Next Page
Loading...
