CAS CI-100A - 3. Key Function Summary; HOLD;SETUP Key Functions; PRINT;FUNC Key Functions; ACC;TOTAL Key Functions

CI-100A Indicator Operation & Service Manual
────────────────────────────────────────────────────────
CAS-USA Corporation
www.cas-usa.com 7
3. Summary of Key function
Key Condition Function
HOLD
SETUP
Weighing/Counting/Percent,
press down <3s
Enter or exit HOLD mode
Weighing/Counting/Percent,
press down > 3s
To enter setup mode
Input data mode,
press down >3s
to input decimal point
Input data mode,
press down <3s
Return to last sub-menu
Menu selection mode Return to last sub-menu
PRINT
FUNC
Weighing/Counting/Percent,
press down <3s
Output data to serial communication port
Weighing/Counting/Percent ,
press down > 3s
select working mode: weighing ,counting or percent
Input data mode The digit on flashed position add 1
Menu selection mode To last item of current menu
ACC
TOTAL
Weighing/Counting/Percent/BMI,
press down <3s
ACCUMULATION function is enabled in configuration
menu : To add up current weight/pieces/percentage to
memory, display times and total of accumulation; in BMI
working mode, to input height
Weighing/Counting/Percent,
press down >3s
ACCUMULATION function is enabled in configuration menu,
To display times and total of accumulation
Input data mode the digit on flashed position subtract 1
Menu selection mode To Next item of current menu
UINT
DATA
Weighing mode,
press down<3s
Change weighing units: kg->lb->lb:oz (not be available in
some conditions)->kg
Counting/Percent mode,
press down < 3s
To enter getting piece weight or unit-percentage-weight
mode (by way of sample or input directly).
Weighing /Counting/Percent mode,
press down> 3s
To input compare data (for weight , pieces or percentage )
of high and low limitation
Display date or time mode,
press down >3s
To set current date or time