CAS CI-100A - 24. Connectors and Jumpers; PCB Connectors Overview; Load Cell, Adapter, and Battery Connectors; 28. Version History

CI-100A Indicator Operation & Service Manual
────────────────────────────────────────────────────────
CAS-USA Corporation
www.cas-usa.com 51
28. Version History
VERSION DESCRIPTION DATE
V1.0 Initial version 2011-09-21
V1.1
(1)Add Geographical Adjustment in Calibration
(2)Add Description for Connectors and Jumpers on PCB in Section24
2011-10-07
V1.2
(1)Add Fig. of load cell wire go to indicator from bottom
(2)Modify 1.6.5.1 section, add 1.11.5 and 1.13.11
(3)Modify “3. Summary of Key function”, add BMI key function
(4)Modify 4.5 MISC-VOL; 4.6TEST
(5)Add “ 8. BMI Working Mode”
(6)Modify the content in TABLE12-1
(7)Modify “15. Display and Calibrate Power Voltage”
(8)Modify 23.1 and 23.2 in “23. Details about Serial Communication”
(9)Add 23.8 section about EH-SCP
2011-12-6
V1.3
(1)Modify some default setting in configuration and user parameters
(2)Modify power supply to 7-9V,500mA;
(3)Modify the max number of load cell that can be powered to 4（x350Ω）
2012-1-14
V1.4
(1) Delete BMI faceplate in “2.Faceplate”
(2) Delete BMI key in “3.Summary of key function”
(3) Delete “1.6.5.3 4 holes socket used”
2012-3-14
V1.5
(1) Modify the range of zero tracking and center of zero point
(2) Add prompt for the prohibition of lb:oz and HOLD for trade application
2012-05-15
V2.0
(1) Add unit “g” and “oz” and modify CONFIG-UNITS item and modify
Table5-1/2 in section5.12
(2) Add “change weight unit” in calibration in section12.5.2
(3) Add contents about Bluetooth module, in section24
2012-6-15
V04.11
(1) Add more controlling of Bluetooth for end user
(2) Add 7O2 & 7E2 selection in USER-COMx-BYT.FMT menu
(3) Add serial communication protocol SCP-12 of NCI3835
(4) Modify EH-SCP serial communication protocol
(5) Delete displaying indicator version, voltage, when power on
2013-08-02
V04.12
(1) Add calibration parameters print out function in calibration section
(2) Modify the operation of accumulation
2013-08-06
V04.12.01
(1) Delete some ways of load cell connect to indicator
(2) Modify the description in CONFIG-PRIM.Ut
(3) Here, V04.12.01 means firmware version is V04.12, this user manual
modification version is 01 on V04.12
2013-08-15