CI-100A Indicator Operation & Service Manual
────────────────────────────────────────────────────────
CAS-USA Corporation
www.cas-usa.com 6
2. Faceplate
Meaning of symbol on faceplate:
2.1 Turn on when scale is stable
2.2 Turn on when scale is at zero point and the gross weight is 0
2.3 NET Turn on when net weight is displaying, and the tare weight is not 0; Turn off when gross weight
is displaying
2.4 TOTAL Turn on when display data is total times or total of weight, pieces or percentage
2.5 lb Turn on when measure unit is lb or lb:oz
2.6 oz Turn on when measure unit is oz or lb:oz
2.7 kg Turn on when measure unit is kg
2.8 g Turn on when measure unit is g
2.9 % Turn on when in percentage weighing mode, measure unit is %
2.10 Pcs Turn on when in counting mode, measure unit is pieces
2.11 PEAK Turn on when in working in HOLD mode and HOLD type is PEAK-HOLD
2.12 HOLD Turn on and flashing/not flashing: working HOLD mode and displaying number is/isn’t live
2.13 BMI Turn on when working in BMI mode
2.14 HI Turns on when data compare is enabled and current data (weight, pieces or percent) is over its
upper setting limitation.
2.15 OK Turns on when data compare is enabled and current data (weight, pieces or percent) is
between its high limitation and low limitation
2.16 LO Turn on when data compare is enabled and current data (weight, pieces or percent) is below
its lower limitation
2.17 Turn on when battery is used or charged
2.18 flash when local wireless module is installed and powered on before link, become steady on
after linked with remote wireless device
2.19 Turn on when remote wireless device is in battery low state
To Next Page
Loading...
