CI-100A Indicator Operation & Service Manual
────────────────────────────────────────────────────────
CAS-USA Corporation
www.cas-usa.com 21
5. Normal Weighing mode
5.1 During key operation, please note to use the second function of one key need pressing the key over 3 seconds;
To input data or select menu, use to process.
5.2 Power on scale: when scale is off, short press ON/OFF key to turn on;
Power off scale: when scale is on, long press ON/OFF key to turn off the scale.
5.3 Change working mode: long press FUNC key, then use to choose and confirm to enter into
weighing mode, counting mode or percentage working mode
5.4 Enter to or exit from HOLD mode: press HOLD key
5.5 ZERO: When the weights is stable and within the zero range, press ZERO key to set new zero point. Please
refer the ZERO and TARE limitations in 5.9 section.
5.6 TARE: When the gross weight is big than zero, and the scale is stable, press TARE key, the indicator will show
net weight of zero, the NET annunciator will be lighted. Please refer the ZERO and TARE limitations in 5.9
section.
5.7 Preset tare weight: long press PRESET key, Pr.Tare will show, and the TARE annunciator flashes, it means it is
in preset TARE weight mode, use to input tare weight, and its unit is same as
the unit that it used before, there’s no limitation to preset tare weight, but it should bigger than zero. After input
a tare weight, “NET” annunciator will be lighted. Note: this indicator can only save one tare weight, the new
tare weight will automatically replace the old one. Also, please refer the ZERO and TARE limitations in 5.9
section
5.8 Clear tare weight: remove any weight on platform, wait till the scale is stable, short press TARE key, please
refer the ZERO and TARE limitations in 5.9section.
To Next Page
Loading...
