E-42
• The illustration on page E-41, for example, shows the value you should
input and the direction setting you should select when the map shows a
magnetic declination of 1° West.
5. When the setting is the way you want, press E to exit the setting screen.
• Selecting OFF for the magnetic declination angle direction causes the
watch’s magnetic declination angle value to change to xx.
Precautions about bidirectional calibration
• You can use any two opposing directions for bidirectional calibration. You
must, however, make sure that they are 180 degrees opposite each other.
Remember that if you perform the procedure incorrectly, you will get wrong
bearing sensor readings.
• Make sure that you do not move the watch while calibration of either
direction is in progress.
• You should perform bidirectional calibration in an environment that is the
same as that where you plan to be taking direction readings. If you plan to
take direction readings in an open field, for example, calibrate in an open
field.
To Next Page
Loading...
