E-45
3. Place the watch on a level surface, and position it so that its 12 o’clock
position points north (as measured with another compass).
4. Press C to start the calibration operation.
• --- is shown on the display while calibration is being performed. When
calibration is successful, the display will show OK and the Digital Compass
Mode (with
0
° shown as the angle value).
• If --- appears and then changes to
ERR
(error) on the calibration
screen, it means that there is something wrong with the sensor. When
ERR
disappears after about one second, try performing the calibration
again. If
ERR
keeps appearing, contact your original dealer or nearest
authorized CASIO distributor to have the watch checked.
To Next Page
Loading...
