E-96
The watch’s STD-AT (standard time)/DST-AT (daylight saving time) setting can be •
configured for auto switching in accordance with a time calibration signal. You also
can manually override the STD/DST setting configured by the calibration signal.
If you use manual override to select a setting, timekeeping will be off by one hour
following an STD/DST switching data in your area, even if the watch is receiving a
time calibration signal. Select the correct STD (standard time)/DST (daylight saving
time) setting to suit your current location (page E-48).
If you are using in the watch in an area where time calibration signal reception is •
not possible, you may need to change your Home City’s STD (standard time)/DST
(daylight saving time) setting manually. Use the procedure under “To toggle the
Home City time between standard time and daylight saving time” (page E-51) to
change the STD/DST setting.
The hands and/or day indications are off.
This could indicate that the watch has been exposed to magnetism or strong impact,
which has caused problems with proper hand and day alignment. Adjust the watch’s
hand and day home position alignment (page E-88).
To Next Page
Loading...
