Using Phrase Pads
EN-58
If you change phrase recording settings, those settings will be
in effect for the subsequent recording operation as well.
Change the recording settings as required when recording a
new phrase.
1.
Press bk FUNCTION.
2.
Use the [1] (V) and [3] (W) bm number keys
to display “Phr Pad”, and then press [6]
(ENTER).
This displays “Phr Set”.
3.
Press 8 RECORD/STOP.
This causes the [RECORD] indicator to flash.
4.
Long-press 8 RECORD/STOP until “Length”
is displayed.
• This enters the phrase recording setting mode.
5.
Use the [1] (V) and [3] (W) keys to select the
item whose setting you want to change.
• For information about setting items, see “Phrase
Recording Setting Items” (page EN-58).
6.
When all the settings are the way you want,
press 8 RECORD/STOP.
This causes the [RECORD] indicator to disappear.
You can use the procedures in this section to copy and delete
phrase sets.
1.
Perform the procedure 1 through 3 under “To
change the phrase set” (page EN-54) to select
the number of the phrase set you want to copy.
2.
Long-press 8 RECORD/STOP until “Copy” is
displayed.
3.
Press the [6] (ENTER) bm number key.
This displays “Phr Set” and stands by for selection of the
copy destination.
4.
Use bn [–] and [+] or the bl dial to select the
copy destination phrase set number.
• Be sure to specify an empty area as the copy
destination.
5.
Press [6] (ENTER).
This displays “Sure?”
6.
Press bn [+] (YES) to execute or bn [–] (NO) to
cancel.
• Pressing bn [+] (YES) displays the message “Wait...”
(operation in progress). Do not perform any operation
while this message is displayed. “Complete” appears
after the operation is complete.
7.
To exit the operation, long-press the [4] (EXIT)
bm number key.
Configuring Phrase Recording
Settings
To configure phrase recording settings
Phrase Recording Setting Items
Item Name
(Display)
Description Settings
Number of
measures
(Length)
Specifies the length (number of
measures) of the phrase to be
recorded.
1 to 16
Quantize
(Quantize)
Specify either recording of notes
in the timing they are played on
the keyboard or automatic
alignment of notes based on a
note value. Selecting a setting
other than “Off” displays a note
value (4: quarter note, d: dotted
note, t: triplets).
Off, 4, 8,
16, 32,
4d, 8d,
16d, 32d,
4t, 8t, 16t,
32t
Metronome
(Metronom)
Specifies whether or not the
metronome should sound during
recording.
On, Off
Pre-count
(Precount)
Specifies whether or not to
sound a pre-count when
recording.
On, Off
Managing Phrase Sets
To copy a phrase set
CTX5000_3000_EN.book 58 ページ ２０１８年２月２６日 月曜日 午後３時５６分
To Next Page
Loading...
Need help?
General
Weight and Dimensions
