Casio CT-X3000 User Manual

EN-13
Connecting to Audio Equipment
Connection requires commercially available connecting cords,
supplied by you.
• The connecting cords should have a stereo mini plug on
one end and a plug that matches the configuration of the
external device on the other end.
• Turn off the Digital Keyboard when making
connections. After connecting, turn down the Digital
Keyboard and external device volume levels whenever
turning power on or off.
• After connecting, turn on the external device and then
the Digital Keyboard.
• If notes from an external device that are played on the
Digital Keyboard sound distorted, lower the volume
setting of the external device.
Enabling Vocal Cut cuts (mutes or minimizes) the vocal in the
sound being input from the AUDIO IN jack. Note that this
function cancels the sound in the center position of the audio,
which may (depending on how the original audio was mixed)
end up canceling something else other than the vocal part.
How vocal cut is performed depends on the sound being
input.
Perform the procedure under “To configure function settings
with the bk FUNCTION button” (page EN-112) and configure
the following setting: Other (Other) 3 Audio In Center Cancel
(AIn CCan) (page EN-117).
• Digital Keyboard built-in effects (reverb, chorus, delay,
DSP) are not applied to AUDIO IN jack input.
You can connect a commercially available microphone* to the
MIC IN jack and output the sound from the microphone
through the Digital Keyboard’s speakers.
* Use a dynamic microphone.
You can adjust the volume level of microphone input with
fm MIC VOLUME. Microphone volume control is
independent from overall keyboard volume.
• Before connecting a microphone, make sure that the
Digital Keyboard and microphone are turned off.
• Before connecting, set both 2 VOLUME and fm MIC
VOLUME to low levels. Adjust volume settings to
appropriate levels after connecting the microphone.
• Microphone input is disabled during demo play.
You can use the Mixer to make individual adjustments to the
reverb, chorus, and delay effects that are applied to
microphone input.
See “Using the Mixer” (page EN-64).
Playing an External Device from
the Digital Keyboard
Center Cancel (Vocal Cut)
Stereo mini plug
fn AUDIO IN jack (Stereo mini jack (3.5mm))
Portable audio player, etc.
CT-X5000: Outputting Sound from
a Microphone
Microphone Settings
fl MIC IN jack (Standard jack (6.3mm))
fm MIC VOLUME knob
CTX5000_3000_EN.book 13 ページ ２０１８年２月２６日 月曜日 午後３時５６分

Casio CT-X3000 Specifications

General

MIDI-keyboard number of keys	61 keys
Metronome	Yes
Product color	Black, White
Sound effects	Chorus, Delay, Reverberation
Maximum polyphony (notes)	64
Display type	LCD
Interface	USB
Headphone outputs	1
Battery type	D
Input voltage	12 V
Power source type	AC, Battery
Number of batteries supported	6

Weight and Dimensions

Depth	384 mm
Width	948 mm
Height	116 mm
Weight	6900 g