Registering and Restoring a Setup (Registration)
EN-70
Each press of the pedal cycles through the currently selected
bank’s registrations (setups) in area number sequence.
1.
Press bk FUNCTION.
2.
Use the [1] (V) and [3] (W) bm number keys
to display “Reg Mem” (Registration Memory),
and then press [6] (ENTER).
3.
Use the [1] (V) and [3] (W) keys to display
“Reg Seq” (Registration sequence).
4.
Use bn [–] and [+] to select the pedal jack that
will be used for the registration sequence
operation.
• This displays the [SEQ] indicator, which indicates that
the registration sequence function is enabled.
• The purpose of the pedal connected to the jack
selected here is registration setup recall only. Normal
pedal functions (functions assigned to the pedal with
the “Using a Pedal” operation, page EN-29) cannot be
used.
5.
When the setting is the way you want, long-
press the [4] (EXIT) bm number key to exit the
setting screen.
6.
Connect a sustain pedal (see “Separately
Available Accessories”, page EN-3) to the jack
you selected in step 4.
7.
At the point when you want to recall the
registration setup, press the pedal.
• Each press of the pedal cycles through the currently
selected bank’s registration setups in sequence from
Area 1.
• Pressing the pedal while the Area 8 setup is recalled
cycles back to the Area 1 setup.
8.
After you are finished recalling the registration
setups using the pedal, perform steps 1
through 5 to turn off the registration sequence
function.
This causes the [SEQ] indicator to disappear.
Using a Pedal to Cycle Through
Multiple Setups (Registration
Sequence)
To play with a Registration Sequence
To select this pedal jack: Display this:
fo PEDAL1 jack Pedal1
fp PEDAL2/EXPRESSION jack Pedal2
(Turn off registration function) Off
CTX5000_3000_EN.book 70 ページ ２０１８年２月２６日 月曜日 午後３時５６分
To Next Page
Loading...
Need help?
General
Weight and Dimensions
