Casio CT-X3000 User Manual

Using the MIDI Recorder to Record
EN-108
1. Perform the procedure under “To enter the
Song Editing Mode” (page EN-99).
2. Perform steps 2 and 3 under “To edit an event”
(page EN-106).
3. Press cs REGISTRATION [8] (EDIT MENU).
4. Use the [1] (V) and [3] (W) bm number keys
to display “Clear”, and then press [6] (ENTER).
5. Perform steps 5 through 7 under “To delete a
specified track in measure units” (page
EN-104).
1. Perform the procedure under “To enter the
Song Editing Mode” (page EN-99).
2. Perform steps 2 and 3 under “To edit an event”
(page EN-106).
3. Press cs REGISTRATION [8] (EDIT MENU).
4. Use the [1] (V) and [3] (W) bm number keys
to display “Copy”, and then press [6] (ENTER).
5. Perform steps 5 through 8 under “To copy a
specified track in measure units and insert
them into a specified location of the same
track” (page EN-104).
Step input is an event editor function. You can use step input
to specify the length and pitch of each individual note (note
event). In the system track, you also can perform step input of
Auto Accompaniment chords (chord events) as well.
• Performing step input into a track that already contains
recorded data will not delete the existing data. This means
you can use step input to add to existing recorded data.
• During step input, use the cs REGISTRATION buttons to
input notes, rests, etc.
1. Perform the procedure under “To enter the
Song Editing Mode” (page EN-99).
2. Perform steps 2 and 3 under “To edit an event”
(page EN-106), and confirm that the [EVENT]
indicator is displayed.
3. Use the [2] (w) and [5] (q) bm number keys to
display the event within the measure from
which you want to start step input.
• The step input start point is the beginning of the
measure.
4. Press cs REGISTRATION [1].
This displays the [STEP] indicator and enters the Step
Input Mode.
• During a step input operation, the current input point
(measure, beat, tick) is shown on the right side of the
display.
To delete events in measure units
To copy events in measure units
Inputting Notes and Chords One-
by-one (Step Input)
To input note events using step input
Displayed
Measure
Note Value
Beat
Tick
CTX5000_3000_EN.book 108 ページ ２０１８年２月２６日 月曜日 午後３時５６分

Casio CT-X3000 Specifications

General

MIDI-keyboard number of keys	61 keys
Metronome	Yes
Product color	Black, White
Sound effects	Chorus, Delay, Reverberation
Maximum polyphony (notes)	64
Display type	LCD
Interface	USB
Headphone outputs	1
Battery type	D
Input voltage	12 V
Power source type	AC, Battery
Number of batteries supported	6

Weight and Dimensions

Depth	384 mm
Width	948 mm
Height	116 mm
Weight	6900 g