EN-59
Using Phrase Pads
1.
Perform the procedure 1 through 3 under “To
change the phrase set” (page EN-54) to select
the number of the phrase set you want to
delete.
2.
Long-press 8 RECORD/STOP until “Copy” is
displayed.
3.
Use the [1] (V) and [3] (W) bm number keys
to display “Clear”, and then press [6] (ENTER).
This displays “Sure?”
4.
Press bn [+] (YES) to delete or bn [–] (NO) to
cancel the delete operation.
• Pressing bn [+] (YES) displays the message “Wait...”
(operation in progress). Do not perform any operation
while this message is displayed. “Complete” is
displayed after the operation is complete.
5.
To exit the operation, long-press the [4] (EXIT)
bm number key.
You can use the procedures in this section to edit individual
phrases. You can delete or copy a phrase, and configure
quantize, key shift, and mixer settings.
• Quantize automatically corrects the timing of recorded
notes to match a note value being used as the quantize
reference.
• Key shift offsets the pitch of recorded sounds in semitone
steps.
To edit a phrase, enter the phrase editing mode.
1.
Press bk FUNCTION.
2.
Use the [1] (V) and [3] (W) bm number keys
to display “Phr Pad”, and then press [6]
(ENTER).
This displays “Phr Set”.
3.
Use bn [–] and [+] or the bl dial to select the
number of the phrase set that includes the
phrase you want to edit.
4.
Long-press bk FUNCTION until the [EDIT]
indicator appears.
• This enters the phrase editing mode. “Clear” will
appear at this time.
1.
Use the procedure under “To enter the Phrase
Editing mode” (page EN-59) to enter the Phrase
Editing mode.
2.
Press the [6] (ENTER) bm number key.
This displays “Phrase” and causes the [P1] indicator to
flash on the display.
3.
Use bn [–] and [+] or the bl dial to select the
number of the phrase you want to delete, and
then press [6] (ENTER).
This displays “Sure?”
4.
Press bn [+] (YES) to execute or bn [–] (NO) to
cancel.
• Pressing bn [+] (YES) displays the message “Wait...”
(operation in progress). Do not perform any operation
while this message is on the display. “Complete” is
displayed after the operation is complete.
5.
To exit the operation, long-press the [4] (EXIT)
bm number key.
To delete a phrase set
Editing a Phrase
To enter the Phrase Editing mode
To delete a phrase
CTX5000_3000_EN.book 59 ページ ２０１８年２月２６日 月曜日 午後３時５６分
To Next Page
Loading...
Need help?
General
Weight and Dimensions
