175
3.21 Laser Setting
This applet is to change the settings for the integrated Laser Scanner. For detail about each
parameter, refer to Chapter 2.2 “Scanner”.
Read barcode Tab
This tab is for specifying bar code symbologies to scan. Multiple symbologies can be specified.
Figure 3-51
Driver Mode Tab
This tab is to set up “Enable” or “Disable” for scanning each symbology of the symbologies listed
in Laser Setting tab and its parameters listed below.
- Min (No. of minimum readable digits)
- Max (No. of maximum readable digits)
- Output format
- Check-digit
- Check-digit output
Figure 3-52
To Next Page
Loading...
