Casio DT-X8 Series Software Manual

38
2.2 Laser Scanner
This chapter describes about detailed specifications of the integrated Laser Scanner.
2.2.1 Basic Specifications
The following industrial standard bar code symbologies are supported by the integrated Laser
Scanner.
Table 2.23 Supported symbologies
Symbology Check Digit Calculation
No. of min.
digits
No. of max. digits
EAN, UPC-A, UPC-B Enable or Disable 8 (fixed) 13 (fixed)
EAN, UPC-A, UPC-B Addon Enable or Disable 10 (fixed) 18 (fixed)
UPC-E Enable or Disable 7 (fixed) 7 (fixed)
UPC-E Addon Enable or Disable 9 (fixed) 12 (fixed)
Code39 Enable or Disable 2 (Note 3) 52
NW7 Enable or Disable 2 (Note 4) 63
Interleaved 2of5 Enable or Disable 4 (Note 5) 94
Industrial 2of5 Enable or Disable 2 67
Code93 Enable or Disable 1 70
Code128 Enable or Disable 1 98
MSI Enable or Disable (Note 1) 1 57
IATA Enable or Disable (Note 2) 1 (Note 6) 65 (Note 6)
GS1 DataBar Omnidirectional Enable 14 (fixed) 14 (fixed)
GS1 DataBar Limited Enable 14 (fixed) 14 (fixed)
GS1 DataBar Expanded Enable 1 74 (Note 7)
GS1 DataBar Stacked Enable 14 (fixed) 14 (fixed)
GS1 DataBar Expanded Stacked Enable 1 74 (Note 7)
Notes:
1. MSI check digit
One of the following MSI check digit calculation methods can be selected.
- 1 digit, mod10
- 2 digit, mod10/mode11
- 2 digit, mod10/mod10
2. IATA check digit
One of the following IATA check digit calculation methods can be selected.
- Calculate number other than end 1 digit
- Calculate coupon number and numeric value segment
- Calculate numeric value segment
- mod10
3. Minimum digit on Code39 symbology
The no. of minimum digits can be set to one digit only when scanning Code39 symbology is
enabled.

Casio DT-X8 Series Specifications

General

Brand	Casio
Model	DT-X8 Series
Category	Touch terminals
Language	English