184
Multi Step Tab
This tab is to specify a reading mode by setting one of the radio buttons enabled in the table
below.
Figure 3-64
Normal Mode
This radio button selects the normal read mode.
Multi Step Mode
This radio button selects the multi-step read mode which continuously reads multiple symbols
until when the Trigger key is released.
Package Mode
This radio button selects the package read mode which continuously reads multiple symbols until
when the Trigger key is released and then outputs a result of reading all the symbols.
Read Count
This field is to set up the number of symbols to read in the Multi-step and Package modes.
Separator
This field is to set up a character as the delimiter inserted in between decoded data of scanned bar
codes in the Package mode.
To Next Page
Loading...
Need help?
General
