CASTLE S SERIES CONTROLLER – TECHNICAL OPERATION GUIDE
Chapter 7 – Sensor
Under Sensor menu, user can manually arm the sensor and set the TimeZone for the sensor
arming.
To enter this menu, press the ‘4’ key at the Main Menu.
The following will be displayed: -
Arming the Sensor
Press ‘1’ to select [1-Arm] menu from Sensor Menu.
This menu item is to manually Arm the sensor by the user.
When choosing this menu, the controller will display as follow: -
Press ‘0’ to select ‘ON’ or ‘OFF’ value.
If the user switch the Sensor to ON position, the controller will display as in the following: -
Value 00 to 60 is allowed. The value indicates the time in seconds. This is the time delay for
the sensor starts arming.
CASS TECHNOLOGY SDN BHD(338857-X) 32
To Next Page
Loading...