CASTLE S SERIES CONTROLLER – TECHNICAL OPERATION GUIDE
d. Door Sensor
The door sensor is use for detecting whether the door is closed or opened. The door sensor is
linked to the reader.
e. Alarm Inputs and General Purpose Outputs
The controller has built-in alarm system with four digital inputs, one relay alarm output and one
general-purpose output. The user can make use of these inputs to monitor other alarm points.
f. Exit Push Button
The user can choose to press a button to exit the protected area. This exit push button is
installed inside the protected area. The user merely presses the button to exit.
g. Power supply
The CASTLE-S Card Access System operates from a 12 V
DC
supply with a battery backup.
Typical power consumption is 12 V
DC
, 350mA.
h. PC Interfacing Unit
You can link the CASTLE-S Controllers to a Personal Computer for total system control by the
PC. The PC software allows you to perform a wide range of supervisory and control from your
computer. The CASTLE-S PC software is running under Windows95 or higher and requires
Pentium166MHz 32 RAM or better computer.
CASS TECHNOLOGY SDN BHD(338857-X) 5