Hardware Setup 2-1
2 - Hardware Setup
This chapter includes these sections describing the various parts of hardware setup:
Power XP 3000 Without Valve
Cabling Installing Components
Printed Circuit Board Settings and
Options
Mounting the XP 3000
Power
The XP 3000 requires a 24VDC power supply with a current rating of at least 1.5A,
provided through a DB-15 connector. Cavro recommends using one power cable for
every two pumps to provide noise immunity; i.e., power should not be daisy-chained to
more than two pumps.
For complete information on choosing a power supply, see Chapter 1, “Getting Started.”
To Next Page
Loading...