Hardware Setup 2-8
Printed Circuit Board Settings and Options
Configuration Jumpers (JP1) for Standard Firmware
Connector JP1 on the XP 3000 printed circuit board is used to configure different modes
of operation (see Figure 2-6). Jumpers are added or removed to enable or disable the
different modes. The jumpers control set the following:
Plunger overload detection (JP1-1)
Communications protocol (JP1-2)
EEPROM, autostart mode (JP1-3)
Baud rate (JP1-4)
Figure 2-6. Configuration Jumpers
NOTE Always power off the XP 3000 before changing any of the jumpers on JP1.
To Next Page
Loading...