CAVRO XP 3000 - Replacing Dispense or Reagent Tubing

To Next Page

To Previous Page

Maintenance 5-4

reading caused by fluid adhering to the tip of the aspirate tubing, a small amount of

surfactant should be added to the water (e.g., Fluorad

â at a 0.01% concentration).

% Coefficient of Variation = (Standard Deviation/Mean) * 100

%CV =

100

−

% Accuracy =

Vol

ected

−

exp

100

where:

sg = specific gravity of H

0 @ 25°C = 0.99707

Vol

expected

= Expected volume to be dispensed

n = number of replicate

X = individual result

X = mean of all results

Replacing Dispense or Reagent Tubing

To replace dispense or reagent tubing, follow these steps:

1 To remove the tubing, use a 5/16" wrench and gently loosen the fittings.

2 Unscrew the fittings and remove the tubing.

3 To install new tubing, insert the fitting into the valve and tighten it finger tight.

4 Using a 5/16" wrench, turn the fitting another ¼ to ½ turn.