Hardware Setup 2-19
Mounting the XP 3000
Numerous tapped M3 x 0.5 mounting holes provide flexibility in mounting the XP 3000;
there are several mounting options:
mounting from the bottom
mounting from the top
mounting from the sides
Mounting requirements vary for pumps with different valves. For more information, see
the specific valve outline drawings. If necessary, custom mounting brackets can be
designed, or, the pump can be mounted directly into an instrument.
NOTE Always mount the pump in an upright position. Failure to do so can cause
problems in priming the system.
To facilitate mounting, Figure 2-12 shows the locations of the threaded mounting holes
(top, bottom, left and right side plates) of the XP 3000.
To Next Page
Loading...