CDVI DIGIWAY PLUS - Maintenance

To Next Page

To Previous Page

DIGIWAY PLUS

INSTALLATION MANUAL

Maintenance

An automatic door, realized through the installation of the operator DIGIWAY PLUS, needs periodic checks ( at least

every 12 months ) as listed in the following points:

1) Check the door balancing and the perfect functionality of the hinges;

2) sliding arm:

2A) Check the xing solidity of the sliding guide to the door and his horizontal alignment;

2B) Check the uency of the sliding block;

2C) Check drive shaft bolt is tight;

2D) Check the correct coupling arm-motor shaft ( solidity of the driving pins );

2E) Possible cleaning of the guide;

3) articulated arm:

3A) Check the xing of the bracket to the door;

3B) Check the solidity of the articulated arm knee;

3C) Check drive shaft bolt is tight;

3D) Check the solidity of the adjustable forearm (2 screws M5 x 12);

4) Check the xing of the motor to the backplate and the backplate to the wall;

5) Check the absence of frictions along the run of the door ;

6) Check of the functionality of the peripherals (radar, electrolock or magnet);

7) In the case of double door with overlapping, check of the perfect synchronization of the 2 leaves;

8) Possible replacement of the battery if the led LP gives the proper message.

cdvi.com

cdvigroup.com