How to fix Ceia Security Sensors when the power is OFF?
If your Ceia Security Sensors power supply unit or the metal detector system is OFF, first check if there is main voltage present. If the problem persists after verifying the voltage, further assistance is needed.
What to do if Ceia Security Sensors keep turning ON and OFF?
If your Ceia Security Sensors power supply unit or metal detector system alternates between ON and OFF, switch the system off. Wait a few minutes to allow any self-resetting components to cool down, then switch the system back on. If the problem continues, further assistance is needed.
What to do if the ejection system of Ceia Security Sensors is faulty or blocked?
If the ejection system of your Ceia Security Sensors is faulty or blocked, check that the ejector is not blocked and verify the ejector connections. After resolving the issue, press the E key.
What to do if compressed air pressure is too low in Ceia Security Sensors?
If the compressed air pressure is too low in your Ceia Security Sensors, check the compressed air connection. After resolving the issue, press the E key.
What to do if Ceia Security Sensors photocell malfunctions?
If your Ceia Security Sensors photocell malfunctions, check there is no pack stuck in front of the photocell and verify the positions of the photocell and the retroreflector. After resolving the issue, press the E key to reset.
What to do if Ceia Security Sensors doesn't eject material?
If the Ceia Security Sensors is not ejecting material, check that the ejector is not blocked. Once the cause of the fault has been eliminated, press E to reset. If the problem continues, further assistance is needed.
What to do if there is overloading of the belt motor in Ceia Security Sensors?
If there is overloading of the belt motor in your Ceia Security Sensors, remove the cause of overloading and press the E key.
What to do if the storage container of Ceia Security Sensors is full?
If the storage container of your Ceia Security Sensors is full, empty it and press the E key to reset the alarm status.
What to do if the storage container of Ceia Security Sensors is not in place?
If the storage container of your Ceia Security Sensors is not in place, put it back in its correct position and press the E key to reset.
General| Operating Frequency | Variable |
|---|---|
| Sensitivity | Adjustable |
| Type | Industrial Metal Detector |
| Operating Temperature | -10°C to +55°C |
| Protection Rating | IP65 |
| Detection Technology | Electromagnetic Induction |
| Dimensions | Variable depending on configuration |
| Weight | Varies by configuration |
| Application | Food, pharmaceutical, textile |
| Battery Life | Not applicable |
To Next Page
