Operator Manual Industrial Metal Detector THS/21
4 FI 028 GB 2K8 v2
1 - iSTrUZioni di SicUreZZA - AvverTenZe
1.1 - Warnings
Read this manual carefully before installing, operating or carrying out
maintenance on the device. Keep the manual in a safe place for future
reference, and in perfect condition. This manual must accompany the
device described therein in the case of change of ownership, and until
the device is broken up.
The functions accessible to users and behaviour of the system, may
differ from what described in this manual, according to the settings
made. Contact the system administrator for any questions.
1.1.1 - General warnings
This equipment complies with the directive 2004/108/EC for industrial •
applications.
All personnel operating with or performing operations on the device must •
have an adequate preparation and shall know the procedures described in
this manual.
Follow the instructions contained in this manual for all operations relating •
to installation, use and maintenance of the device. CEIA cannot be held
responsible for any damage resulting from procedures which are not
expressly indicated in this manual, or from any lack of attention, either
partial or total, of the procedures described therein.
This manual must accompany the device described therein in the case of •
change of ownership, and until the device is broken up.
1.1.2 - Use warnings
If the device is stored for a long period in temperatures outside the •
operating range, wait for the temperature of the detector to come back
within that range before switching on.
Whenever there is any suggestion that the level of protection has been reduced, •
the device should be taken out of service and secured against any possibility
of unintentional use, and authorised service technicians should be called.
The level of protection is considered to have been reduced when:
the device shows visible signs of wear and tear, especially on parts that ensures -
the device protections (boxes, gaskets, glands, fixing screws, etc.);
the Power Supply Box is not correctly closed; -
the ground connections are not compliant; -
the device has suffered mechanical or electrical stress (shocks, bumps, etc..); -
To Next Page
