Operator Manual Industrial Metal Detector THS/21
20 FI 028 GB 2K8 v2
3.4.3 – Stop
If nothing passes through the metal detector for the length of time set
by parameter ST (see Programming Manual), the conveyor belt stops
automatically.
Emergency button
An extra emergency button is mounted on the conveyor belt to stop it in
case of malfunction or danger.
If necessary, the main system switch can also be used for this purpose.
The emergency button has been pressed.
Press R to restore the normal functioning.
If the Stop Time (ST) parameter is set to a value other than zero, if any
product passes in front of the photocell during the number of minutes
that you set, the conveyor belt stops by itself, without any signalization.
To Next Page
