48
3. On the Sample Name page, the specific details for
the upcoming analysis can be entered:
- SAMPLE ID provides an identifier to best
represent the sample that will be analyzed. If
each sample needs a unique Sample ID, that can
be set in the next step.
- BATCHING should be turned to Single or Batch,
based on the number of samples that have been
dried and are ready for ORACLE analysis.
- SAMPLE MASS can be logged by pressing the
weight box and following the instructions. The
sample Mass can be based on the original mass
of the sample prior to drying, or the ORACLE can
provide results based on Dry Weight of the
sample, or the mass after the drying process.
Note: If using the balance, choose Balance, follow the
instructions on the screen to Tare the weight of the
sample pad/film, then add the correct amount of sample
to the pad/film and record the initial weight.
Note: If manually inputting the weight, simply choose
Manual and type the initial weight that was previously
recorded, then press the Next icon to continue.
- AUTO INCREMENT will assign an incremental
number to the end of the Sample ID. This can be
toggled ON or OFF to fit the user’s needs.
4. Once all the values have been correctly entered,
press the NEXT icon to continue.
At this stage, if the samples have not been placed in the Air Oven to begin drying, do so now.
5. Once the samples have been fully dried, follow the procedures outlined in the ORACLE Station Sample
Preparation, preparing and analyzing one sample at a time.
To Next Page
Loading...
Need help?
General
