ABS System Fault Indicator Lamp
Only applicable to vehicles equipped with ABS system.
When the key switch is in the ON position, the ABS system will conduct a self-test,
and this indicator lamp will turn on for about 3 seconds and turn off. If this indicator
lamp is on for a long time, it indicates that the ABS system has a fault. At this
time, turn on the ABS fault diagnosis switch for 1~3 seconds, and the ABS system
fault code indicator lamp will flash the fault code. Please contact the CENNTRO
authorized service center to check and repair the vehicle.
Safety Belt Indicator Lamp
When the driver does not fasten the safety belt, the indicator lamp will be
on to remind the driver to fasten the safety belt.
Turn Indicator Lamps (Left and Right)
This lamp is used to indicate the operation of the turn signal lamp. Normal
flashing indicates that all steering lamps work normally, and flash indicates
that at least one steering lamp on the same side is faulty.
Insulation Fault Indicator Lamp
If the indicator lamp is continuously on, it indicates that there is leakage
fault in the high-voltage electronic control system of the whole vehicle.
If this indicator lamp is on when you are driving the vehicle, you should
immediately find a safe place to stop, and contact the CENNTRO authorized service
center to check and repair the vehicle.
High Beam Indicator Lamp
When the light composite switch is in the high beam position, the
indicator lamp will be on; this lamp is also on when dimming operation is
performed.
Low Beam Indicator Lamp
When the light composite switch is in the low beam position, the indicator
lamp will be on.
To Next Page
Loading...
