Charging Indicator Lamp
When the electric vehicle is plugged into the charging gun for normal
charging, the lamp will be on.
Hazard Warning Indicator Lamp
When the hazard warning lamp switch is turned on, this indicator lamp
will be on, and the front, rear, left and right turn signal lamps light up and
flash at the same time to remind other vehicles and pedestrians to pay
attention.
Battery Fault Indicator Lamp
This lamp is used to indicate the working status of the power battery. When
the lamp is on, it indicates that the power battery is faulty. At this time, the
motor may still work, but the electric control system will adjust the power,
speed and other operating parameters of the motor according to the impact of
the fault until it is finally forced to shut down. If the indicator lamp is continuously
on during the use of the vehicle, please contact the CENNTRO authorized service
center to check and repair the motor.
Parking Brake Indicator Lamp
When the driver applies the EPB parking brake, the indicator lamp will light
up to remind the driver that the vehicle is in braking status; after releasing
the EPB parking brake, if the air pressure is lower than 5.40 bar (540 kPa),
the indicator lamp will be on, otherwise the indicator lamp will be off. When the
vehicle starts, confirm whether the indicator lamp is off and whether the spring
parking brake is released.
Low Brake Air Pressure Warning Lamp
When the air pressure in the air reservoir is lower than 5.35 bar (535 kPa)
when the vehicle is running, the lamp will be on and the buzzer on the
instrument will sound; when the vehicle is stationary (the parking brake
indicator lamp is on), if the air pressure in the air reservoir is lower than 5.35 bar
(535 kPa), the low air pressure alarm light is on but the buzzer does not sound.
When the above conditions occur, the vehicle can only start driving after the brake
air pressure reaches the requirements or the fault is eliminated.
To Next Page
Loading...
