• When braking slightly, ABS does not participate in the braking process. Only
when emergency braking occurs, ABS will enter the working state.
• Before troubleshooting, disconnect the ABS power fuse (15 A and 30 A)
connected to the ABS control unit, and then connect it after troubleshooting.
• When the indicator lamp starts to flash, the ABS function will exit. At this time,
there is only conventional braking but no anti-lock function. You should drive
carefully.
• After disconnecting the ABS power supply, there is only conventional braking,
and you should drive carefully at this time.
To Next Page
Loading...
