CENTURION SYSTEMS D5 SMART - Page 10

page 10 www.centsys.com
SPECIFICATIONSSECTION 2
2.2. Technical Specications Continued
TABLE 1 CONTINUED
1.Canoperateoasolarsupply,consultyourlocaldealerforassistance
2. Based on 25°C ambient temperature and unit not in direct sunlight
3. Based on a motor push force of less than 50% of rated (Starting and Running forces)
4.Gateopeningandclosingspeedscanbeconguredtorunslowerdependingontherequirementsofindividualinstallations
5. Can increase battery capacity for longer standby times
6. Based on 4m gate, excluding all accessories
7. Multiple buttons per remote can be used
Fuse Protection Type Rating
Main Control Card Serviceable 25A
Aux. Supply Resetable Fuse
12V 600mA
or
24V 3A
(10sec Pulse)
Charger (Mains Supply) Non-serviceable 3A slow-blow
Motor push force - starting 30kgf
Motor push force - rated 17kgf
Gate mass - maximum 500kg
Gate length - maximum 100m
Gate speed (varies with load)
4
30m/min @ 17kgf
Manual Override Lockable with key release
Operations in standby (6Ah Batteries)
Half day
5,6
44
Full day
5,6
35
Collision Sensing Electronic
Operating temperature range -15°C to +50°C
Onboard receiver type
Code-hopping multichannel receiver
with selective add and delete
Receiver code storage capacity 1500 Remotes
7
Receiver frequency 433.92MHz
Degree of protection IP55
Mass of unit packed (with standard kit, but
excl. rack and battery)
9.1kg
Packaging dimensions (with standard kit,
but excl. rack and battery)
325mm wide x 244mm deep
x 445mm high