CENTURION SYSTEMS D5 SMART - Mounting the Rack

page 36 www.centsys.com
7.9. Mounting the Rack
The rack must be securely mounted to the side of the gate. It must be
parallel with the gate rail and there must be a 2-3mm gap between the
rack teeth and the teeth of the pinion.
The D5 SMART is supplied with
the Pinion Spyder, which greatly
enhances the accuracy and speed of
achieving the 2-3mm gap between
the Pinion and the gate's rack.
Fit the Pinion Spyder onto the Pinion
of the D5 SMART by aligning its
teeth with the gaps between the
teeth of the D5 SMART's Pinion.
Ensure that the D5 SMART Gearbox
is in Manual Override. Refer back to
Section 7.7 - "Manual Override".
Start with the gate either fully open
or fully closed.
Slide the D5 SMART back towards
the gate to where the Pinion will sit
just under where the rack will be
xedtothegate.
Rest the rack directly onto the Pinion
Spyder while welding / bolting the
rack into position.
Leveltheotherendandxthatend
to the side of the gate, as shown in
Figure 55.
Pinion
Spyder
Pinion
Spyder
Gate Rack
D5 SMART
Pinion
Level this end of the rack,
and x it to the gate
Spirit Level
Pinion
Foundation Plate
Pinion Spyder
tooth
FIGURE 53
FIGURE 54
FIGURE 55. THE RACK AND OPERATOR FROM THE GATE'S PERSPECTIVE
Refertotheinstructionsonhowtoxthedierenttypesofracktoagatein
Section 7.9.1. - "FittingDierentTypesofRacktotheGate".
OPERATOR INSTALLATIONSECTION 7
Pinion
Spyder