CENTURION SYSTEMS D5 SMART - Introduction

page 5 www.centsys.com
INTRODUCTIONSECTION 1
1. Introduction
The D5 SMART is a domestic and light-industrial operator designed to open and close sliding
gates weighing up to 500kg. A custom-designed gearbox moulded from robust engineering
polymers, coupled to a powerful 24V DC motor, provides fast and reliable automation for
entrances to homes and small housing estates.
Thesystemoperatesotwo12Vbatterieshousedinsidetheoperatorusingaswitch-mode
charger to maintain the battery in a fully-charged state. The batteries provide critical power
failure protection.
Anon-contactHallEectSensorwasselectedtoensurereliabilityandpositionalaccuracy.
TheHallEectSensorishighlyresistanttodust,oil,dirtorinsectingress,thereforeensuring
that the D5 SMART opens and closes gates reliably and accurately.
Advanced features of the D5 SMART logic controller include:
• Interactive graphic user interface via a smartphone application
• Automated setup of gate endpoints (limits)
• Independently-adjustable motor speed in both opening and closing directions
• Fail-safe collision detection and auto reverse (adjustable sensitivity)
• Smooth, adjustable start/stop (ramp-up/ramp-down)
• Multiple operational modes
• Selectable, adjustable Autoclose
• Pedestrian (partial) opening
• Positive Close Mode
• Independent safety inputs for opening and closing beams
• Automatic beam test for both opening and closing beams
• Advanced lightning/surge protection
• Onboard NOVA code-hopping radio receiver with full channel-mapping capability
(limited to 1500 remotes
1)
1. Multiple buttons per remote can be used