15 – Monitoring T2S - ETH User Manual – v1.4
Hardware
Green Orange Red Status
FS
Boot loader Web interface ON and in operation
S FS
System file OK but no config file *.ini
S S S
Error SD Card / File
S S
Error no configuration.ini
6.2 Signaling Information
As it is designed to be used in the same shelf as former T2S, T2S ETH inherits the connections on the back.
Note: The terminal connector accepts maximum wire size of 0.5 mm
2
.
Important remarks:
In a system with several shelves, T2S ETH is usually located in the first one (although it’s not mandatory) but relay
signaling contacts will be terminated in the T2S ETH installed shelf. The above connection is just an example, actual
connection will be based on your shelf design and connections.
If the T2S is included in one complete system including for example Termination box or some customers packages, the
terminal will be located somewhere else. (Refer System user manual).
To Next Page
Loading...