CE+T Power T2S-ETH - Warranty and Safety Conditions; Disclaimer; Technical Care

3. Warranty and Safety Conditions
*
WARNING:
The electronics in the power supply system are designed for an indoor, clean environment.
When installed in a dusty and/or corrosive environment, outdoor or indoor, it is important to:
• Install an appropriate filter on the enclosure door, or on the room’s air conditioning system.
• Keep the enclosure door closed during operation.
• Replace the filters on a regular basis.
Important Safety Instructions, Save These Instructions.
3.1 Disclaimer
• The manufacturer declines all responsibilities if equipment is not installed, used or operated according to the
instructions herein by skilled technicians according to local regulations.
• Warranty does not apply if the product is not installed, used and handled according to the instructions in the
manuals.
3.2 Technical care
• This electric equipment can only be repaired or maintained by a “qualified employee” with adequate training.
Even personnel who are in charge of simple repairs or maintenance are required to have knowledge or
experience related to electrical maintenance.
• Please follow the procedures contained in this Manual, and note all the “DANGER”, “WARNING” AND “NOTICE”
marks contained in this Manual. Warning labels must not be removed.
• Qualified employees are trained to recognize and avoid any dangers that might be present when working on or
near exposed electrical parts.
• Qualified employees understand how to lock out and tag out machines so the machines will not accidentally be
turned on and injure employees working on them.
• Qualified employees also understand safety related work practices, including those by OSHA and NFPA, as well
as knowing what personal protective equipment should be worn.
• All operators are to be trained to perform the emergency shut-down procedure.
• Never wear metallic objects such as rings, watches, or bracelets during installation, service and maintenance of
the product.
• Insulated tools must be used at all times when working with live systems.
• When handling the system/units pay attention to sharp edges.
* These instructions are valid for most CE+T Products/Systems. Some points might however not be valid for the
product described in this manual
8 – Monitoring T2S - ETH User Manual – v1.4
Warranty and Safety Conditions