Assembly preparation for Long shield ILS basic version
Before assembling the hardware, check for correct
fit of the coupling module; see "Check the coupling
module" on page17
1. If a handle set is already existent in the door,
dismantle it. An existing Euro profile cylinder,
provided it is of appropriate length, can continue to be
used with the Long shield ILS.
If the door does not have a Euro profile cylinder, it is
advisable to assemble it before assembling the Long
shield ILS.
You can now start with the assembly.
Assembly on the outside of the door
1. Push the two FIXING SCREWS WITHOUT CABLE SLIT in the
lower and the middle screw placement slot of OUTSIDE
FITTING.
The fixing rings on the head of the screws serve to
fix the screws in the position that matches the
existing holes.
Page 22 of 141 Long shield ILS
4.5 Assembling basic version (for Long shield holes)
Overview: Master media usage
Help & troubleshooting Technical data
Maintenance & disposal
Operation Administration
Assembly
Basics
To Next Page
Loading...
