8. Pull the INSTALLATION TUBE on the opposite side of the
door.
9. Guide the OUTSIDE FITTING through the Long shield holes
of the door.Push the square spindle through the lock
follower.
While guiding, keep the cables tout so that they lie
correctly in the cable slit. The cables must not get
squeezed or jammed!
10. Align the Euro profile cylinder, if it does not sit
correctly in the outside fitting.
The outside fitting is now temporarily fixed, so that you
can continue with assembly of the inside fitting.
Assembly on the inside of the door
Depending on the size of the lock follower, you may
possibly need adaptor sleeve for the square spindle
(see "Adaptor sleeves for square spindle" on
page18). Use adapter sleeves in this case.
Long shield ILS Page 25 of 141
4.5 Assembling basic version (for Long shield holes)
Overview: Master media usage
Help & troubleshooting Technical data Maintenance & disposal Operation Administration
Assembly
Basics
To Next Page
Loading...
