4. Put a WASHER and a NUT each on the top and the middle
FIXING SCREW.
5. Depending upon whether the Euro Profile cylinder is
assembled or not, the spring clip will be assembled.
a) In case the Euro profile cylinder is assembled, the spring
clip will not be assembled. Put only the WASHERS and NUTS
on both of the lower FIXING SCREWS.
Long shield ILS Page 27 of 141
4.5 Assembling basic version (for Long shield holes)
Overview: Master media usage
Help & troubleshooting Technical data Maintenance & disposal Operation Administration
Assembly
Basics
To Next Page
Loading...
