b) In case no Euro profile cylinder is assembled, then the
spring clip will be assembled. Put the SPRING CLIPS, WASHERS
and NUTS on the lower FIXING SCREWS.
6. Tighten NUTS by hand.
While tightening the FIXING SCREW WITH CABLE SLIT hold
the cables upwards, so that these are not jammed!
7. Undo the grubsCREW FROM THE inside lever hANDLE
SLIGHTly, to remove any possible stress from the
square spindle.
Page 28 of 141 Long shield ILS
4.5 Assembling basic version (for Long shield holes)
Overview: Master media usage
Help & troubleshooting Technical data
Maintenance & disposal
Operation Administration
Assembly
Basics
To Next Page
Loading...
