8. Check whether the handle set is correctly aligned.
9. Tighten the NUTS with the wrench (max. 1.2 Nm).
While tightening the FIXING SCREW WITH CABLE SLIT hold
the cables upwards, so that these are not jammed!
10. Re-tighten the GRUBSCREW OF The iNSIDE LEVER Handle.
Long shield ILS Page 29 of 141
4.5 Assembling basic version (for Long shield holes)
Overview: Master media usage
Help & troubleshooting Technical data Maintenance & disposal Operation Administration
Assembly
Basics
To Next Page
Loading...
