11. Run the cables through the middle of the BATTERY
MODULE.
12. Use the slot-head screwdriver to screw the red cable
onto the positive terminal (+) and the black cable onto
the negative terminal (-).
13. Slide the BATTERY MODULE from top to bottom on the
ASSEMBLY PLATE, until it snaps in.
- Should the top most FIXING SCREW be in the way, then,
instead of sliding it from top to bottom, you can also
press the battery module into the recess of the
mounting plate from the front.
Page 30 of 141 Long shield ILS
4.5 Assembling basic version (for Long shield holes)
Overview: Master media usage
Help & troubleshooting Technical data
Maintenance & disposal
Operation Administration
Assembly
Basics
To Next Page
Loading...
