Assembly preparation - Long shield ILS on rosette holes.
Before assembling the hardware, check for correct
fit of the coupling module; see "Check the coupling
module" on page17
1. In case a (rosette) handle set is already existent in the
door, disassemble it. An existing Euro profile cylinder,
provided it is of appropriate length, can continue to be
used with the Long shield ILS.
If the door does not have a Euro profile cylinder, it is
advisable to assemble it before assembling the Long
shield ILS.
You can now start with the assembly.
Assembly on the outside of the door
1. Unscrew the counter sunk screws of OUTSIDE SHIELD
with the Allen key and raise the ASSEMBLY PLATE of the
outside shield.
2. Run the cables through the right rosette hole of
ASSEMBLY PLATE OF THE OUTSIDE SHIELD.
Page 50 of 141 Long shield ILS
4.7 Assembling wide shield (for rosette-holes)
Overview: Master media usage
Help & troubleshooting Technical data
Maintenance & disposal
Operation Administration
Assembly
Basics
To Next Page
Loading...
