3. Remove the fixing rings from allFIXING SCREWS.
4. Insert the other two FIXING SCREWS WITHOUT CABLE SLITS in
the lower elongated holes of the ASSEMBLY PLATE OF
OUTSIDE SHIELD.
5. Place the fixing rings on the on both the lower FIXING
SCREWS and push it up to the assembly plate to fix it in
the position the matches the existing holes.
6. Insert a FIXING SCREW WITHOUT A CABLE SLIT in the left
rosette hole and the FIXING SCREW WITH CABLE SLIT in the
right rosette hole of ASSEMBLY PLATE OF OUTSIDE SHIELD.
Ensure that the cables run through the grooves on
the edge.
Make sure that the cable slit of the fixing screw
faces upwards and the cables lie exactly in the cable
slit.
Long shield ILS Page 51 of 141
4.7 Assembling wide shield (for rosette-holes)
Overview: Master media usage
Help & troubleshooting Technical data Maintenance & disposal Operation Administration
Assembly
Basics
To Next Page
Loading...
