7. Screw the assembly plate of the outside shield again
to the outside fitting.
Make sure thereby that the cables are not pinched
or jammed.
8. Insert the SQUARE SPINDLE in the coupLING FOLLOWER.
Make sure that the elongated hole is level.
Make sure that the ball of the square spindle in the
drill hole latched in the coupling follower.
9. Feed both cables into the INSTALLATION tube.
Page 52 of 141 Long shield ILS
4.7 Assembling wide shield (for rosette-holes)
Overview: Master media usage
Help & troubleshooting Technical data
Maintenance & disposal
Operation Administration
Assembly
Basics
To Next Page
Loading...
