10. Run the cables with the help of the INSTALLATION TUBE
through the corresponding screw hole in the door.
- Turn the installation tube to and fro slightly while feeding
it in, so that it moves forwards more easily.
11. Pull the INSTALLATION TUBE on the opposite side of the
door.
12. Guide the OUTSIDE FITTING with both of the top FIXING
SCREWS through the rosette holes of the door and both
the lower fixing screws through the PZ holes. Push
the SQUARE SPINDLE through the lock follower.
While guiding, keep the cables tout so that they lie
correctly in the cable slit. The cables must not get
squeezed or jammed!
13. Align the Euro profile cylinder, if it does not sit
correctly in the outside fitting.
Long shield ILS Page 53 of 141
4.7 Assembling wide shield (for rosette-holes)
Overview: Master media usage
Help & troubleshooting Technical data Maintenance & disposal Operation Administration
Assembly
Basics
To Next Page
Loading...
