3. Use the Allen key to screw the grub screw into the
INSIDE LEVER HANDLE, to secure the SQUARE SPINDLE.
4. Put the NUTS on both of the upper FIXING SCREWS.
While doing so, keep the cables upwards, so that
they do not get pinched or jammed!
5. Depending upon whether the Euro Profile cylinder is
assembled or not, the spring clip will be assembled.
a) In case the Euro profile cylinder is assembled, the spring
clip will not be assembled. Put only the WASHERS and NUTS
on both of the lower FIXING SCREWS.
b) In case no Euro profile cylinder is assembled, then the
spring clip will be assembled. Put the SPRING CLIPS, WASHERS
and NUTS on both of the lower FIXING SCREWS.
Long shield ILS Page 55 of 141
4.7 Assembling wide shield (for rosette-holes)
Overview: Master media usage
Help & troubleshooting Technical data Maintenance & disposal Operation Administration
Assembly
Basics
To Next Page
Loading...
