8. Guide the FIXTURE RING over the inside INSIDE LEVER HANDLE
and push it up to the end of the inside lever handle.
9. Pull the FIXTURE RING hand tight WITH THE CES ring
spanner.
Do not over-tighten the fixture ring with too much
force! Otherwise you may damage the handle set.
The battery replacement is completed successfully.
7.5.4 Signalling after battery insertion
Signalling Meaning
Start sequence for offline locking devices: No error
Start sequence for online locking devices:Device is online and is connected to the
Access-Point
Start sequence for online locking devices:Device is online but no connection to
Access-Point is possible
Firmware error. Execute a firmware update. If the problem persists, contact your
CES partner.
In case a system error exists, it will be displayed immediately after the
start sequence, see "System error" on page107.
Long shield ILS Page 97 of 141
7.5 Battery management
Overview: Master media usage Help & troubleshooting Technical data
Maintenance & disposal
Operation Administration Assembly Basics
To Next Page
Loading...
