PROPILOT 700
50
224 RUDDER DRIVE FAULT
• The Pilot computer has sent a drive command to the drive unit
but the Rudder Feedback Unit has not detected a change in the
rudder position.
Check that the Rudder Feedback has not become disconnected
from the Rudder Arm, also check that the steering system,
especially the motor, is operating the rudder gear correctly.
Ensure that the drive unit cables have not become disconnected or
loose.
If You Need Assistance
If you do ever need to contact your Cetrek Dealer or Distributor, it
would save time if you could make a note of the following details
for them:
Model number:
Serial number:
Software version number:
A description of the failure.
To Next Page
Loading...
