Champion Eseries - Section Assembly

38
Section Assemby
1. Section joints must be sealed
with foodgrade silicon sealant.
2. Mask the joint edges with
a quick-release masking tape.
3. Apply a 1/8" bead of Foodgrade
silicon sealant. Apply moderate
pressure on the gun to ensure the
sealantllsthejoint.
4. Wait 45-seconds for the sealant
tormslightly.Thenwipethejoint
with a damp cloth.
Do not wait longer than 1 minute for
thesealanttorm.Thesealant
will not wipe correctly.
5. If the sealant dries longer than
1 minute, DO NOT try to wipe
the joint. Allow the sealant 30
minutes to dry, then cut the
sealant out of the joint and
begin again.
6. Wait 10-seconds after wiping the
joint, then remove the masking
tape.
7. Continue sealing the joints.
DO NOT SEAL more than
one joint at a time. The sealant
will dry faster than you can
work the joint.
Installation Instructions
Section Assembly - Seal Joint Sections